Plug for Polytherme, Polyclean, and Polymax
POLYTHERME large capacity drinker 4 balls
Feature-Benefits :
Reversible lid with an innovative opening and closing system.
Opening from the front or rear part of the drinker. The lid can be easily removed.
Piece to link 2 drinkers together.
Isothermal drinker designed with a double-wall rotomolded polyethylene trough insulated with polyurethane foam. Isothermal lid with double seal, and an insulated ball or bowl for an easy access of the animals.
It keeps the water at a positive temperature down to - 30°C by absorbing the natural calories in the soil and provides cool water in case of high temperatures.
These drinkers are standard fitted with an innovative opening and closing system.
Opening from the front or the rear part thanks to the multifunction hinges.
Or the lid can be removed anytime from the drinker without any tool.
This design and the new opening system enable the drinker’s installation in any place without having a wall or a gate as an obstacle, which could prevent the drinker from an easy opening.
Fitted with :
- 1 seal to be set under the drinker.
- 1 connection hose protected by an insulating sleeve.
It can be used indoors or outdoors, fixing to the ground on a raised slab of about twenty cm. For good insulation position the seal under the tray.
The Polytherme large capacity drinker is available in isothermal ball and cast aluminium bowl versions which are interchangeable. It is fitted with a 42 l/mn (4 bars) float valve including 2 floats. In its factory fitted version, it is effective down to -30°C and lower with the immersion heater option. An internal technical space allows easy water connection and the addition of the heating option and a general shut-off valve. An orientable isothermal locking key allows the passage of networks and the connection and linking of two troughs coupled together, while maintaining thermal performance. The lid is easy to handle thanks to captive screws and easy to keep open thanks to its rear hinges. The tank is fitted with two side drain bungs and one central drain bung Ø 90 mm.
Delivered with a ground seal and insulated sleeve to place around the supply pipe.
- Material
- rotomolded polyethylene resin
- Length
- 1220 mm
- Width
- 1150 mm
- Height
- 580 mm
- Capacity
- 180 l
- Model
- 4 balls
- Pressure
- network
- Drinker
- Polytherme large capacity
- System
- constant level
- Mechanism
- float valve tap
- Fastening
- ground
- Device
- isotherm
- Connection diameter
- 1/2" (15/21 mm) - female
- Packaging
- boxed
- Flow rate
- 1 to 53 l/min
- Sales unit
- Unit
- Float valve
- Pressure network in brass (P1138341)
- Drain plug
- 3 x Ø 90 mm
Accessories and options
